Spite Sprite Case
This is a case for the Spite Sprite. It's designed to allow plugging into the back of an Amiga 500. The case screws together with four M2.5x12 screws (though x10 will probably work too).
The design accomodates the full flange of a 23 pin connector, but it will also work with the 3D-printable parametric D-sub connector.
Print recommendations
The bottom of the case has a multi-layer counterbore that allows it to print face-up with no supports. This is designed for a layer height of 0.2mm.
Downloads
Case-Bottom.stl
87.78KiB
2025-09-03 23:31:49
Case-Top.stl
91.68KiB
2025-09-03 23:31:49
Case.FCStd
1.78MiB
2025-09-03 23:31:49